Progress Lighting P2526-20 Bedienerhandbuch PDF herunterladen (Seite 13)

Operating Your Fan 10.

Touching

ceiling

Figure 19

WARNING

TO REDUCE THE RISK OF PERSONAL INJURY,

DO NOT BEND THE BLADE HOLDERS

WHILE INSTALLING, BALANCING THE

BLADES, OR CLEANING THE FAN. DO NOT

INSERT FOREIGN OBJECTS BETWEEN

ROTATING FAN BLADES.

Turn on the power and check the operation of

your fan. There are two pull chains available in

your fan:

1. 3-speed pull chain- it controls the fan speed as

follows: 1 pull- High, 2 pulls- Medium, 3 pulls-

Low, and 4 pulls- Off.

Speed settings for warm or cool weather

depend on factors such as the room size,

ceiling height, number of fans, and so on.

The slide switch controls directions: forward

(switch left) or reverse (switch right).

Warm weather - (Forward) A downward air flow

creates a cooling effect as shown in Figure 20.

This allows you to set your air conditioner on a

higher setting without affecting your comfort.

Cool weather - (Reverse) An upward airflow

moves warm air off the ceiling area as shown in

Figure 21. This allows you to set your heating

unit on a lower setting without affecting your

comfort.

NOTE

WAIT FOR FAN TO STOP BEFORE

CHANGING THE SETTING OF THE

SLIDE SWITCH.

Blade blancing

All blades are grouped by weight. Because

natural woods very in density, the fan may

wobble even though the blades are weighed

equally.

The following procedure should correct

most fan wobbling problems. Check after

each step.

1. Check that all blade and blade arm

screws are secure.

2. Most fan wobbling problems are caused

when blade levels are unequal. Check this

level by selecting a point on the ceiling

above the tip of one of the blades. Measure

this distance as shown in Figure 19. Rotate

the fan until the next blade is positioned for

measurement. Repeat for each blade. The

distance deviation should be equal within

1/8".

3. Use the enclosed Blade Balancing Kit if

the blade wobble is still noticeable.

4. If the blade wobble is still noticeable,

interchanging two adjacent (side by side)

blades can redistribute the weight and

possibly result in smoother operation.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 31 32

Kommentare zu diesen Handbüchern

Keine Kommentare