Progress Lighting P2526-20 Bedienerhandbuch PDF herunterladen (Seite 7)

Hanging the Fan

REMEMBER to turn off the power.

Follow the steps below to hang your fan

properly.

NOTE: This ceiling fan is supplied with two

types of hanging assemblies; the standard

ceiling installation using the ball/ downrod

ass embly mountin g, and t he "close-to-

ceiling" mounting. The "close-to-ceiling"

mounting is recommended in rooms with less

than 8-foot ceilings or in areas where

additional space is desired from the floor to

the fan blades. When using standard downrod

installation, the distance from the ceiling to

the bottom of the fan blades will be

approximately 14.5 inches. The "close-to-

ceiling" installation reduces the distance

from the ceiling to the bottom of the fan

blades to approximately 9 inches.

Standard ceiling mounting

Note: For mounting angles between 20-45

degrees, remove the canopy bottom cover

installed on the bottom of the canopy.

1. Remove the canopy ring from the canopy.

(Figure 5).

4.

2. Remove the mounting plate from the

canopy by loosening the four screws on the

top of the canopy. Remove the two non-

slotted screws and loosen the slotted screws.

This will enable you to remove the mounting

plate (Figure 6).

3.

4. Route the wires exiting the top of the fan

motor through the decorative motor collar

cover then the canopy ring. Make sure the

slot openings are on top. Route the wires

through the canopy and then through the

ball/downrod assembly (Figure 7).

5. Loosen, but do not remove, the set screws

on the collar on the top of the motor housing.

Remove the bolt, lock pin and loosen set

screws from the top of the motor assembly.

6. Align the holes at the bottom of the downrod

with holes in the collar on top of the motor

housing (Figure 7). Carefully insert the hanger

pin through the holes in the collar and downrod.

Be careful not to jam the pin against the wiring

inside the downrod. Insert the locking pin

through the hole near the end of the hanger pin

until it snaps into its locked position as noted in

the circle inset of Figure 7.

7. Re-tighten the set screws on the collar on the

top of the motor housing.

Figure 5

Figure 6

Hanger pin

Canopy ring

Ball/downrod

assembly

Motor wires

Pin in

locked

position

Motor collar

Locking pin

Tighten

screws

firmly

Collar cover

Ceiling

canopy

Figure 7

Loosen but do not remove

Remove

WARNING

FAILURE TO PROPERLY INSTALL

LOCKING PIN AS NOTED IN STEP 6 COULD

RESULT IN FAN LOOSENING AND

POSSIBLY FALLING.

Canopy ring

1 2 3 4 5 6 7 8 9 10 11 12 ... 31 32

Kommentare zu diesen Handbüchern

Keine Kommentare