Progress Lighting P2526-20 Bedienerhandbuch PDF herunterladen (Seite 8)

5.

Figure 9

Figure 10

Motor collar

Close-to-Ceiling Mounting

1. Remove the canopy ring from the canopy.

(Figure 5)

2. Remove the mounting plate from the

canopy by loosening the four screws on the

top of the canopy. Remove the two non-

slotted screws and loosen the slotted

screws. This will enable you to remove the

mounting plate (Figure 7).

3. Remove the decorative canopy bottom

cover from the canopy by depressing the

three studs (Figure 8).

4.

Remove the bolt, lock pin and set screws

from the top of the motor assembly.

Ceiling

Canopy

Plastic

gasket

Metal

gasket

Screw with

lock washer

Canopy

ring

Figure 8

Canopy bottom

cover

5.

washers (every other one) securing the

motor collar to the top of the fan motor

housing. (Figure 9).

Remove three of six screws and lock

6. Route the wires exiting the top of the fan

motor through the plastic gasket, canopy

ring, canopy and the metal gasket, place the

plastic gasket over the remaining three

screws, place the canopy ring, canopy and

the metal gasket over the motor collar at the

top of the fan motor (Figure 10).

7. Align the three mounting screw holes on the

metal gasket with the holes on the motor

collar at the top of the fan motor and fasten,

using the three screws and lock washers

provided with metal gasket.

8. Tighten the three mounting screws securely.

Screw with

lock washer

(3 of 6 places)

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 31 32

Kommentare zu diesen Handbüchern

Keine Kommentare